Kimball Office Footprint Assembly Instructions

Footprint
®
Modular Casegoods– Desks

Tools Required


Drill with 1/8" and #2 Phillips tip bits

5/16" Hex socket

Level

Measuring tape

Flat head screwdriver

Hardware Provided


Metal to Worksurface: #10 Phillips pan head particle
board screws.

Metal to Metal: #10 x 1/2" hex washer head drill screws

Installation Planning


To reduce installation time, it is recommended you install
modular casegoods in the following order:
1. Pedestal
2. End Panel
3. Modesty Panel
4. Undersurface Lateral File or File Center

General Information


Four Spacers are included with all Pedestals and Under-
surface Lateral Files. These ARE NOT used unless
freestanding unit is part of systems installation, e.g. a
freestanding return joined to a systems top.

Removing Drawers

To remove Pedestal Box and Undersurface Lateral File
drawers (Figure B):
1. Begin with top drawer (Figure C). Extend drawer fully.
2. Insert flat head screwdriver in between pedestal drawer
and slide. Pry slide away from drawer slightly (Figure C).
3. Put one hand underneath drawer. Lift front of drawer up to
disengage from front drawer slide channel hooks.
4. When front of drawer is disengaged, pull entire drawer
towards you, supporting it from the bottom. This should
disengage drawer from rear drawer slide channel hooks.
5. Set all drawers aside and slide drawer channels back into
case. Do not try to remove the entire drawer slide.
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
2498904 Revision -
Assembly Instructions
Figure A
Figure B
Figure C
1