Kimball Office Footprint Assembly Instructions

Footprint
®
Sliding Door, Metal Panel
Mount Overhead for Xsite

Tools Required


Phillips Screwdriver or Cordless Drill with #2 Phillips
Bit

7/16" Wrench, Socket, or Nut Driver

Level

Hardware Required


Overhead Mounting Brackets (2 each)

1/4" Flat Washer (8 each)

1/4" Acorn Nut (8 each)

Ganging Bracket (If installing 2 cabinets side-by-side)

#8 X 5/8" Phillips Head Sheet Metal Screws (6 each, used
with Ganging Brackets)

Installation

1. If installing on an Xsite panel with Tackable Acoustic
Tiles, verify that there is a mid-frame support located
where the bottom of the cabinet will be. (Figure A)
2. Remove the inner back panels from the cabinet. Lift the
panel straight up using the hole provided near the bottom.
Grasp the panel at the top and pull toward you. While
holding the panel horizontally with the top facing the front
of the cabinet, turn the panel approximately 30 degrees and
pull straight out to remove it. (Figure B)
3. Insert the threaded studs on the mounting brackets through
the holes on the back of the cabinet. The top inside stud
goes through the round hole. The other studs go through
the slotted holes.
4. From the inside of the cabinet place a 1/4" flat washer and
1/4" acorn nut on each of the studs. Using a 7/16" wrench,
socket, or nut driver, tighten the acorn nuts, making sure
that the mounting bracket is square to the cabinet. (Figure
C)
5. Repeat for the opposite side.
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
2464685, Revision -
Figure A
®
Figure B
Figure C
Washer
Acorn Nut
Assembly Instructions
Mid-frame Support
Mounting Bracket
1