Kimball Office Footprint Assembly Instructions

Footprint
®

File Center

Tools Required


Level

Drill with #2 Phillips Bit

Flat Head Screwdriver

3/16" Hex Head Wrench

Product Required


Metal to worksurface: #10 X 1" Philips Pan Head Drill
Screws.

Four spacers for use with systems surfaces only

General Information


These instructions provide the basic information to install
Footprint Flat Profile File Center. (Figure A):
- To Kimball systems TRAXX®-mounted, panel-mounted
and modular worksurfaces.

Panel-mounted systems worksurfaces are illustrated.

One person can perform all operations, although two may
be required to handle larger, heavier units.

Removing Drawers


Drawers must be removed to secure storage to worksurface.
To remove box drawers and lateral file drawer:
1. Begin with top drawer and extend drawer fully. (Figure B).
Note: Hooks in drawer channel correspond to notches
in drawer body.
2. Insert flat head screwdriver in between drawer and slide.
Pry slide away from drawer slightly. (Figure C).
3. Put one hand underneath drawer. Lift front of drawer up
to disengage from front drawer slide channel hooks.
(Figure C).
4. When front of drawer is disengaged, pull entire drawer
towards you, supporting it from the bottom. This should
disengage drawer from rear drawer slide channel hooks.
(Figure C).
5. Set all drawers aside and slide drawer channels back into
case. Do not try to remove the entire drawer slide.
To Remove File Drawer
1. Extend drawer fully. (Figure D).
2. Each drawer slide has a lever: one is depressed, the other is
lifted. Simultaneously while lifting and depressing the levers,
hold drawer level and pull drawer toward you. This should
disengage drawer from file center unit.
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
1699149, Revision C
Assembly Instructions
Figure A
Figure B
Figure C
1