Racelogic VBOX LapTimer User Manual page 40

Speed Smoothing
Press the square button to cycle through
five smoothing settings. The default setting is 1.
Speed Alert
When enabled, Speed Alert will only operate
when the VBOX LapTimer is set to Speed Mode.
The Speed Alert Mode is set to off (unticked) by
default.
When you enable Speed Alert, your LapTimer will
beep and have solid red LEDs if it logs a speed of
more than the set speed alert value for longer
than 1 second. The alert will stop when your
logged speed goes below the set speed alert
value.
Speed Alert
Alert Speed
Alert Sound
Back
Press the square button when this line is highlighted to
enable the Speed Alert mode. This is disabled by
default.
Press the square button to change the Alert Speed. You
will see two arrows (up and down) appear next to the
number. Use the two arrow buttons on the device to
increase/decrease the speed to a set value between 0
and 999. Press the square button again to confirm your
selected speed.
Press the square button to toggle the Alert Sound on or
off.
Press the square button with this line highlighted to exit
the Speed Alert settings and go back to the Speed
Settings.
https://en.racelogic.support//Product_Info/Lap_Timing_and_Pit_Timing/VBOX_LapTimer/
User_Guide_%E2%80%93_VBOX_LapTimer/05_Menu_Options_%E2%80%93_VBOX_LapTimer
40