Racelogic VBOX LapTimer User Manual page 30

The display will return to the Predictive Lap Timing mode
when your speed increases to 5 km/h over the
configured Delta-T Speed Mode value.
If you have set your VBOX LapTimer to Predictive Lap
Timing mode and you have enabled Delta-T Speed
Mode;
• When your speed drops below 65 km/h for a
minimum of 1.5 seconds, the display will change to
show your current speed alongside your Delta-T.
• When your speed increases to 70 km/h, the display
will revert to Predictive Lap Timing mode.
Delta-T Speed Mode
Speed
Time Delay
Back
Combo G LED Mode
When you have selected this mode, the LapTimer shows
combined g information via the LEDs while also
showing Delta-T information on the display.
It encourages you to truly push your car at braking
Press the square button when this option is highlighted
to enable the mode. A tick will appear when enabled.
Press the square button to change the speed. You will
see two arrows (up and down) appear next to the value.
Use the two arrow buttons on the device to increase/
decrease the speed value. Press the square button
again to confirm your selected value.
Press the square button to cycle through the available
time values. Each time you press the button the value
will increase in increments of 0.5 s, up to 5.0 s, before it
cycles back to 0.0 s. Press one of the arrow buttons to
move away from the setting and save the displayed
time.
Press the square button with this line highlighted to exit
the Delta-T Speed Mode settings and go back to the
Predictive Lap Timing Settings.
https://en.racelogic.support//Product_Info/Lap_Timing_and_Pit_Timing/VBOX_LapTimer/
User_Guide_%E2%80%93_VBOX_LapTimer/05_Menu_Options_%E2%80%93_VBOX_LapTimer
30