Yamaha MBK XMAX 2014 Service Manual page 215

EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
d. Install the left grip end.
TIP
There should be 2.5 mm (0.10 in) of clearance
"b" between the handlebar grip and the grip end.
b
2
1
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
5. Install:
• Rear brake master cylinder "1"
• Rear brake master cylinder holder
Brake master cylinder holder bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Align the projection "a" on the brake master cyl-
inder with the hole "b" in the handlebar.
• First, tighten the front bolt, then the rear bolt.
1
6. Install:
• Throttle grip "1"
• Throttle cables "2"
• Right handlebar switch "3"
Throttle cable bracket screw
2.5 Nm (0.25 m·kgf, 1.8 ft·lbf)
Right handlebar switch screw
2.3 Nm (0.23 m·kgf, 1.7 ft·lbf)
a
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
b
a a
TIP
• Be sure to position the washer between the
throttle grip and the right handlebar switch.
• Lubricate the end of the throttle cables and the
inside of the throttle grip with a thin coat of lith-
ium-soap-based grease.
• Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
• Be sure to slide the throttle cable rubber cover
to its original position.
3
a
2
b
▲▲▲
7. Install:
• Right grip end "1"
TIP
There should be 3.5 mm (0.14 in) of clearance
"a" between the throttle grip "2" and the grip end.
8. Install:
• Front brake master cylinder "1"
• Front brake master cylinder holder
TIP
• Align the projection "a" on the brake master cyl-
inder with the hole "b" in the handlebar.
• First, tighten the front bolt, then the rear bolt.
4-72
HANDLEBAR
Right grip end bolt
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
2
Brake master cylinder holder bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
1
LS
3
a
1