Yamaha MBK XMAX 2014 Service Manual page 29

2. "RESET" button
3. Hold the "RESET" button pushed for 15 to 20
seconds.
SELECT RESET
1
1. "RESET" button
4. Release the "RESET" button, and the oil trip
value will reset to zero.
TIP
If the engine oil is changed before the oil change
indicator comes on (i.e. before the periodic oil
change interval has been reached), the indicator
must be reset after the oil change for the next
periodic oil change to be indicated at the correct
time. To reset the oil change indicator before the
periodic oil change interval has been reached,
follow the above procedure.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Turn the key to "ON".
2. Check that the oil change indicator comes on
for a few seconds and then goes off.
3. If the oil change indicator does not come on,
check the electrical circuit.
Refer to "SIGNALING SYSTEM" on page
8-23.
V-belt replacement indicator "V-Belt"
This indicator flashes every 20000 km (12500
mi) when the V-belt needs to be replaced.
After changing the V-belt, reset the V-belt re-
placement indicator.
[To reset the V-belt replacement indicator]
1. Turn the key to "ON".
2. Push the "TRIP" button until "V-belt" (V-belt
replacement tripmeter) is displayed in the
odometer and trip meter display. While "V-
INSTRUMENT FUNCTIONS
belt" is displayed, push the "RESET" button
for 3 seconds. The V-belt replacement trip-
meter value will flash.
SELECT RESET
1
TRIP
INFO
1. "TRIP/INFO" switch
2. "RESET" button
3. Hold the "RESET" button pushed for 15 to 20
seconds.
SELECT RESET
1
1. "RESET" button
4. Release the "RESET" button, and the V-belt
trip value will reset to zero.
TIP
If the V-belt is replaced before the indicator
comes on, be sure to reset the V-belt replace-
ment indicator so that it will come on at the next
correct interval.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Turn the key to "ON".
2. Check that the V-belt replacement indicator
comes on for a few seconds and then goes
off.
3. If the V-belt replacement indicator does not
come on, check the electrical circuit.
Refer to "SIGNALING SYSTEM" on page
8-23.
1-20
2