Fiat DOBLO Owner's Handbook Manual page 206

● the change of trajectory is not
accompanied by operation of the
turn signals
● the Electronic Stability Control is
activated and not in operation
● the vehicle is not connected to a
trailer or an electric bicycle carrier
● normal driving behaviour (system
detects dynamic driving style, i.e.
pressure on the brake or accelerator
pedal)
● roads with poor lane markings
● no spare wheel is used
● the driver needs to be active during
the correction
● the vehicle is not driven in a tight
corner
Activation
204
If the system is activated, the LED in the
button Ó is not illuminated. To activate
the system when the system is
deactivated, press Ó.
The system is operational at vehicle
speeds between 65 km/h / 40 mph and
180 km/h / 112 mph and if lane markings
are detectable. The driver must hold the
steering wheel with both hands. The
Electronic Stability Control system must
be activated.
The control indicator a flashes yellow
during trajectory correction.
If the driver wishes to maintain the
trajectory of the vehicle, he can prevent
the correction by keeping a firm grip on
the steering wheel, e.g. during an
avoiding manoeuvre. The correction is
interrupted if the turn lights are operated.
There is no correction triggered when the
turn lights are operated and during a few
seconds after turn lights have been
switched off.
If the system detects that the driver is not
holding the steering wheel firmly enough
during an automatic correction of
trajectory, it interrupts the correction. A
warning message in the Driver
Information Centre accompanied by a
warning chime alerts the driver when
immediate driver´s action is required.
Deactivation
To deactivate the system, press and hold
Ó. Deactivation of the system is
confirmed by the illuminated LED in the
button. In the Driver Information Centre
solid grey lines are displayed.
Recommended deactivation
It is recommended to deactivate the
system in the following situations:
● Road surface in poor condition
● Unfavourable climatic conditions
● Slippery surfaces, e.g., ice
The system is not designed for driving in
the following situations:
● Driving on a speed circuit
● Driving with a trailer
● Driving on a rolling stand
● Driving on unstable surfaces
Fault
In the event of a fault, a and C
appear in the instrument panel,
accompanied by a display message and
a warning chime. Contact a dealer or a
qualified workshop to have the system
checked.