Table of Contents
Advertisement
through the ventilation holes. In particular,
bend cables away from the ventilation holes as
near to the connectors as possible.
7
Technical Data
Requirements on Mains Circuits.
• Mains Circuits of overvoltage category II
up to 300 V AC rms.
7.1 24V Power supply ratings
The 24V System and 24V Digital/Fast digital
input power specifications are listed in the fol-
lowing table.
Input power
UN
24V System
DC 24 V
24V Dig/Fdigx
DC 24V
7.2 Drive power supply ratings
The drive power specifications for the system
housing are listed in the following table.
Drive power
UN
DPx
DC +15 .. +75V
7.3 Motor connector ratings
The
motor
connector
NY4120/10 modules are specified in the fol-
lowing table.
Motor connector
UN
Mx.0 and Mx.1
DC 3x 0V .. 75V
8
Standards
8.1 Used standards
The components of the system housing corre-
spond to the following standard.
• EN61010-1:2010 (IEC61010-1:2010)
(Safety requirements for electrical equip-
ment for measurement, control and labor-
atory use - Part 1: General requirements)
• EN61000-6-2:2005 (IEC61000-6-2:2005)
(Immunity for industrial environments)
• EN61000-6-4:2007/A1:2011
(IEC61000-6-4:2006/A1:2010)
(Emission for industrial environments)
June 13, 2019
IN
IN
Fan
Natural
convection
3,0A
3,0A
4,5A
4,5A
IN
IN
Fan
Natural
convection
12,0A
6,0A
ratings
for
the
IN
IN
Fan
Natural
convection
0 .. 7Arms
0 .. 3Arms
Page 4 of 13
8.2 CE marking
Declaration of Conformity
The system housing described in the present
instructions, comply with the requirements and
the target of the following EU directive and
with the following harmonized European
standards:
• Low Voltage Directive 2006/95/EC
This product is a built-in unit which, owing to
its installation characteristics, is not able to
comply with the regulations for complete appa-
ratus, machines or installations from the outset.
For this reason, it may only be used for built-in
purposes. The product may only be assessed
with regard to its electrical and mechanical
safety as well as to environmental effects (for-
eign bodies, moisture) after it has been in-
stalled in the product intended for the final us-
er. After the product has been installed, its
EMC properties may change. Hence the prod-
uct intended for the final user (complete appa-
ratus, machines or installations) should be in-
spected with regard to its EMC properties by
the manufacturer of the product intended for
the final user.
• EMC Directive 2004/108/EC
Maintaining the EMC directive presuppose an
EMC adapted installation of the devices within
the installation of the machine. The complied
limit values and standards are specified in the
Rexroth Manual of associated product. The
regulations for the structure and the installation
in this manual must be maintained and real-
ized. Tests were run using a typical installation
in a test assembly that conforms with the
standards. These Rexroth products are built-in
devices for a product for the final user. The test
results cannot be transferred to every state as
installed in every product intended for the final
user. This declaration does not therefore assure
the EMC characteristics of the product for the
final user.
R911339004-07_BAL_DOC
Advertisement
Table of Contents
