Switching On The Device; Switching Off The Device; Opening An Operating Mode - BRAND HandyStep touch Operating Manual

7 Operation

7.3 Switching on the device

a.
Press the power button.
ð
The main menu opens.
Start Motor Init
If using the device after a long period of non-use, you will be prompted to perform a motor initializa-
tion after switching on the device:
a.
Confirm the message "Start Motor Init."
ð
Motor initialization is carried out.
ð
The device moves the tip adapter into working position.
ð
The main menu opens.
Charging stand/USB cable
The device switches on when it is placed in the charging stand or when the USB cable is connected.
This also stops standby mode.

7.4 Switching off the device

a.
Drain and eject the tip, see Dispensing liquid, p. 77 or Ejecting the tip, p. 76
b.
Press the power button.
ð
A message appears asking if you would like to switch off the device. Confirm by tapping
cel by tapping
c.
If the power button is pressed for approx. 1 s, the device goes into standby.
If the power button is pressed for longer than 2 s, you are asked if you would like to switch off the
device.
d.
Confirm message.
e.
Hang the device upright in the holders provided. If the device is placed in the charging stand,
charging begins. In doing so, the LED of the charging stand lights up.
If the touchscreen display or the device no longer respond, consult the Device behavior, p. 97 section
in the chapter Troubleshooting.

7.5 Opening an operating mode

You select an operating mode from the main menu. The actual task (e.g. dispensing) is carried out in
the operating mode.
74
Operating manual
.
HandyStep® touch, HandyStep® touch S 997486
. Can-