Bcache Tag Parity Error; Controlling Bcache Block Parity Calculation; Bcache Data Single-Bit Correctable Ecc Error; Icache Fill From Bcache - Compaq EV68A Hardware Reference Manual

Compaq microprocessor reference manual
Table of Contents

Advertisement

C_STAT[DC_PERR] is set.
C_ADDR contains bits [42:6] of the Dcache duplicate tag address of the block that
contains the error.
When enabled, a machine check (MCHK) is posted. The MCHK is taken when not
in PALmode.

8.7 Bcache Tag Parity Error

The Bcache tag parity is checked on all Bcache tag references, including references
invoked by system probes. If an error is detected, the following actions are taken:
Bcache tag parity errors are not recoverable.
C_STAT[BC_PERR] is set.
C_ADDR contains bits [42:6] of the Bcache address of the block that contains the
error.
When enabled, a machine check (MCHK) is posted. The MCHK is taken when not
in PALmode.

8.8 Controlling Bcache Block Parity Calculation

Parity is calculated for either valid Bcache blocks or all Bcache blocks. The calculation
is controlled by the value in Cbox CSR BC_VALID_MODE in the WRITE_MANY
chain, as follows:
If the MSB of BcTag_H is less than the value of Maximum PA in Table 4–13, then
BC_VALID_MODE=1 and parity is calculated for only valid Bcache blocks.
If the MSB of BcTag_H is greater than or equal to the value of Maximum PA in
Table 4–13, then BC_VALID_MODE=0 and parity is calculated for all Bcache
blocks.
For example, if BcTag_H[38:20] and Maximum PA is 36, then 38 is greater than or
equal to 36 and BC_VALID_MODE=0 and parity is calculated for all Bcache blocks.

8.9 Bcache Data Single-Bit Correctable ECC Error

The following actions may trigger Bcache data ECC errors:
Icache fill, data possibly used by Icache
Dcache fill, data possibly used by load instruction
Bcache victim during an ECB instruction or during a Dcache/Bcache miss
The recovery mechanism depends on the action that triggered the error.

8.9.1 Icache Fill from Bcache

For an Icache fill, the LSD ECC checkers detect the error, and bad Icache data parity is
generated for the octaword that contains the quadword in error. If an error is detected,
the following actions are taken:
The hardware flushes the Icache.
C_STAT[ISTREAM_BC_ERR] is set.
21264/EV68A Hardware Reference Manual
Bcache Tag Parity Error
Error Detection and Error Handling
8–5

Advertisement

Table of Contents
loading

This manual is also suitable for:

21264

Table of Contents