Some software, like OS/2,
minimum of 8MB to 16MB of RAM to work correctly. Check
your software documentation for the minimum memory
requirements. If necessary, add additional memory using the
instructions in Chapter 4.
Printer Problems
The printer does not work at all.
Check that the printer has power and is properly
the computer. Also make sure your printer has paper in it.
The printer prints garbled information.
Check the printer manual for the printer's correct DIP switch or
control panel settings.
Also, make sure you have the proper drivers installed for your
printer and make sure you've selected the correct printer
within your software application.
Option Card Problems
A newly installed option card is not working correctly.
Make sure the option card is installed correctly and is
well-seated in its slot. Run the SETUP program to update your
computer's configuration after you install the card. Also,
perform setup procedures for any software you are using with
the option card.
See the documentation that came with the option card to set
any necessary DIP switches or jumpers on the card.
6-12 Troubleshooting
®
®
UNIX,
or NetWare 3.11, needs a
to
connected