Starting The Setup Program - Epson ActionDesk 4000 User Manual

System booting options
Security password and anti-virus features
Green PC options, such as the time intervals before the
system and the hard disk drive go into low-power standby
mode.
SETUP also allows you to see s ummary information about your
system.
The SETUP program and the factory default options for your
computer are stored in the computer's ROM BIOS (read-only
memory, basic input/output system). The configuration
information you enter is stored in an area of memory called
CMOS RAM. This memory is backed up by a battery, so it is
not erased when you turn off or reset the computer.

Starting the SETUP Program

When you start your computer, it performs some power-on
diagnostics. During these diagnostics, you may see the
following message:
Press <F2>
Press F2 to run SETUP. This message is only on the screen for a
few seconds. If you missed it, restart your computer and try
again. (If you want, you can disable this message in SETUP.)
If, during power-on diagnostics, the system detects an error in
your system configuration, you hear two beeps and see an
error message followed by this message:
Press <Fl>
Press F2 to run SETUP.
Running SETUP and Installing Drivers
2-2
to enter SETUP
to resume,
<F2>
to Setup