Using Setup - Epson ActionDesk 4000 User Manual

Chapter 2
Running SETUP and lnstalling Drivers
Your computer has a configuration program, SETUP, contained
within the BIOS chip on the system board. This program allows
you to change the settings for your hardware configuration.
The computer also comes with several drivers and utilities on
diskette. These drivers and utilities let you take advantage of
some of the advanced features of your system, like the local bus
hard disk drive interface and the local bus SVGA capabilities of
the built-in video interface.
This chapter describes using SETUP and installing the local bus
IDE driver. If you want information about installing video
drivers or utilities, see the Readme files included on the
diskettes that came with your system.

Using SETUP

You may need to run the SETUP program the first time you use
your computer. If your system came unconfigured, you need to
define how it is set up. If your system was configured for you,
you may want to check the settings or adjust the date and time.
You also may need to run SETUP again later if you change
your configuration.
SETUP lets you verify or change the following:
System settings such as date, time, diskette drives, and type
of video display
Automatic or manual selection of hard disk drives
Automatic or manual selection of advanced hardware
features for optimizing system performance
Running SETUP and Installing Drivers
2-1