Epson ActionDesk 4000 User Manual page 44

Follow these steps to install the IDE driver:
1. Insert the Drivers diskette 1 in drive A.
2. Log onto the IDE subdirectory on drive A.
3. Type the following and press
INSTALL
4. Follow the instructions on the screen to install the IDE driver
on your hard disk. This installation program changes your
system's CONFIGSYS file so the system loads the IDE
driver as part of its startup procedure. If you select the IDE
driver for Windows, this program also modifies the
SYSTEM.INI file for Windows.
Note
You should always install the IDE driver for DOS. If you
are using Windows, make sure you also install the IDE
driver for Windows. Windows must be installed before
you install the driver for Windows.
After installing the driver, the system reboots.
Note
Not all hard disk drives can take advantage of the local bus
IDE interface. To take advantage of this feature, your hard
disk drive must support a 32-bit data path that utilizes
double-word I/O. To find out whether your hard drive
utilizes double-word I/O, see the hardware specifications
for the drive or contact the vendor of the drive and request a
product specification.
Enter:
Running SETUP and Installing Drivers
2-17