Connecting The Drive And Power Cables - Epson ActionDesk 4000 User Manual

Connecting the Drive and Power Cables

To connect the drive to the computer, you need to connect both
the drive ribbon cable and a power supply cable. Follow the
steps below.
1. If you are installing a diskette drive, locate the diskette drive
ribbon cable. (The connector in the middle of the cable is
already connected to the system board.)
2. If you are installing a drive with a card-edge connector make
sure you align the key-way (the plastic divider) with the
gap in the drive
If you are installing a 3.5-inch diskette drive with a header
connector in the bottom slot, see page 5-19 for instructions
on connecting the cable.
as shown below.
connector,
Installing and Removing Drives
5-17