Table of Contents
Advertisement
b. To move to the next number in the entry, press the
right, or the
button to move left. Press once for each number space
you want to move. The underscore ( _ ) indicates the selected number.
c.
When the IP address is set correctly, press the
new IP address, and continue to the Subnet Mask configuration.
2.
To change the Subnet Mask entry, use the same procedure described in
steps a. and b. above.
When the Subnet Mask is set correctly, press the
new entry, and continue to the Default Gateway configuration.
3.
To change the Gateway entry, use the same procedure described in steps
a. and b. above, then press the
continue.
4.
The IP address is verified and a confirmation message displays if it is
configured correctly.
After five seconds, the Configuration menu displays again.
If any part of the address is misconfigured, an error message displays.
After five seconds the display returns to the point where the first
misconfiguration was detected.
Repeat the process for setting the IP address, Subnet Mask, and Gateway
until the address is verified.
Installing the Appliance
button to move
button to apply the
button to apply the
button to apply the new entry, and
Quick Install
2-13
Advertisement
Table of Contents
