Table of Contents
Advertisement
Installing the E-MSM720
W A R N I N G
C a u t i o n s
Installation Precautions
■
The rack or cabinet should be adequately secured to prevent it
from becoming unstable and/or falling over.
Devices installed in a rack or cabinet should be mounted as low as
possible, with the heaviest devices at the bottom and progressively
lighter devices installed above.
■
Wall-mount the E-MSM720 with network ports facing up (away
from the floor). Do not wall-mount the E-MSM720 with the
network ports facing down (toward the floor) or ventilation ducts
facing up or down.
■
Use only the AC/DC power adapter supplied with the E-MSM720 for
connection to an AC power source.
Ensure the power source circuits are properly grounded, then use the
■
power cord supplied with the E-MSM720 to connect it to the power
source.
■
If your installation requires a different power cord than the one supplied
with the E-MSM720, ensure the cord is adequately sized for the E-
MSM720's current requirements. In addition, be sure to use a power cord
displaying the mark of the safety agency that defines the regulations for
power cords in your country. The mark is your assurance that the power
cord can be used safely with the E-MSM720. If the supplied power cord
does not fit, contact HP Networking support.
■
When installing the E-MSM720, the AC outlet should be near the E-
MSM720 and should be easily accessible in case the E-MSM720 must be
powered off.
Do not install the E-MSM720 in an environment where the operating
■
ambient temperature might exceed 45°C (113°F). This includes a fully-
enclosed rack. Ensure the air flow around the sides and back of the E-
MSM720 is not restricted.
■
Ensure all port covers are installed when the port is not in use.
2
2-1
Hide quick links:
Advertisement
Table of Contents
