Operating Two Or More Projectors With The Remote Control; Setting The Projector Id; Checking The Projector Id - Epson PowerLite 1716 User Manual

Using the Remote Control
36
Operating Two or More Projectors with
the Remote Control
If you're using more than one projector, you can control all the
projectors—or just selected ones—by using the projector and remote
control ID system. First assign a unique ID number to each projector.
Then set the remote control to match the ID of the projector you
want to operate. This lets you control it without affecting the others.

Setting the Projector ID

The projector's default ID is set to Off. This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the button on the remote control. You see the
Menu
projector's menu screen.
2. Select
Extended > Projector ID
3. Use the pointer button to highlight the new ID, and press
to select it.
Enter
4. When done, press

Checking the Projector ID

To check the ID of a specific projector:
1. Point the remote control at the projector you want to check.
.
to exit the menu system.
Menu