note
Only the Epson Ethernet
adapter is guaranteed to
work. Other brands may not
be compatible.
If you see a message asking
you to insert a LAN or
memory card, check to make
sure your Ethernet adapter is
properly inserted.
Setting Up Network Projection
90
Connecting to a Wired Network
With the optional wired LAN module, you can connect the projector
to your network and configure it with an IP address. This provides an
alternative to connecting to the projector wirelessly.
1. If the optional wireless module is installed in the projector,
remove it as described on page 89. Then insert the wired LAN
module into the projector and replace the cover plate.
2. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the
port on the projector.
LAN
3. Point the remote control at the projector and press the P
button.
4. Press the
EasyMP
as the source.
5. Press the
button on the remote control, select the
Menu
menu, then press
Network
6. Choose
Network Configuration
7. Choose
Wired LAN
screen:
button on the remote control to select EasyMP
.
Enter
and press
and press
. You see the following
Enter
Power
.
Enter