Solving Problems
130
The message
Not Supported
■
Make sure the correct
(see page 103).
Make sure your computer's resolution doesn't exceed UXGA
■
×
(1600
1200) and the frequency or refresh rate is supported by
the projector (see page 144). If necessary, change your computer's
resolution setting.
Only part of the image is displayed.
Press the
button on the remote control to select a
■
Aspect
different setting (see page 32).
If projecting from a computer, press the
■
remote control. Also make sure the image
correct in the Signal menu (see page 103).
■
Check the projector's
or
, depending on the size of your computer's
Normal
Wide
display panel.
Make sure your computer is not set to display an extended
■
desktop.
Press the
button on the remote control to cancel the E-Zoom
■
Esc
function.
Make sure your computer's resolution setting is correct. Ideally, it
■
×
should be 1024
768 to match the projector's native resolution.
If this option isn't available, select one of the other compatible
video formats listed on page 144.
You also may need to modify existing presentation files if you
■
created them for a different resolution. See your software
documentation for specific information.
is displayed.
is selected in the Signal menu
Input Signal
Auto
Position
setting (see page 103). Select
Resolution
button on the
setting is