Subscribe to Our Youtube Channel
Related Manuals for Clarke STRONG-ARM CFC100
Summary of Contents for Clarke STRONG-ARM CFC100
- Page 1 FOLDING CRANE MODEL NO: CFC100 PART NO: 7611005 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC12/22 Rev 5...
-
Page 2: Specification
Weight (kgs) Please note that the details and specifications contained herein are correct at the time of going to print. However Clarke International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 3: General Safety Rules
(as marked on the jib). IMPORTANT: If the load capacity label becomes worn or illegible, contact Clarke Parts and service department, on 0208 988 7400 for a replacement. 5. Only use chains, slings, hooks etc. with a rated capacity equal to, or greater than that of the load. -
Page 4: Parts Supplied
Unpack the crane on to a clean flat area of hard standing, and visually inspect components to ensure that no damage was suffered in transit. Should any damage be apparent, please contact your Clarke dealer immediately. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 5: Component Parts List
COMPONENT PARTS LIST Description No Description Chain and hook assembly Pump handle Bolt M12x80 Main support post Flat washer M12 Lockwasher M12 Bolt M16 x 90 Nut M12 Nut M8 Jib extension Castor wheel Chain Bolt M14 x 100 Lock Pin Flat washer M14 R-clip Nut M14... - Page 6 ASSEMBLY 1. Fit the castor (24) to the base 3. Slide the right leg (32) into the (28) using 4 bolts (16), lock base (28) as shown, line up the washers (17) and nuts (23). holes and insert two lock pins (26). 2.
- Page 7 7. Fix the ram (21) into position using 8. Attach the jib (7) to the top of the bolt (22), washer (12) and nut (13 main support post (20) using bolt (15), washer (12) and nut (13). 9. Connect the top of the ram (21) 10.
-
Page 8: Operation
OPERATION RAISING THE JIB Important;- Make sure that the hook is directly above the point of lift, which in turn is directly above the centre of gravity of the load. 1. Use the end of the pump handle (19) to close the valve by turning it fully clockwise. - Page 9 STORAGE ALWAYS get assistance when folding the crane into its storage configuration. 1. When storing, the stabiliser must be locked in the down position. You may need to tilt the crane back slightly to position the stabiliser correctly During use During storage The stabiliser should be placed in the The stabiliser should be placed in the...
-
Page 10: Maintenance
5. A slight dampness on the ram is normal but where leakage is apparent the ram seals must be renewed. Consult your Clarke service department. EVERY THREE MONTHS 1. Pins and bolts should be removed and inspected for wear, deformation or cracks. -
Page 11: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the STRONG-ARM CFC100 and is the answer not in the manual?
Questions and answers