Related Manuals for Clarke CFC100
Summary of Contents for Clarke CFC100
- Page 1 1 TONNE FOLDING CRANE 1 TONNE FOLDING CRANE MODEL No CFC100 PART No 7611005 OPERATING & MAINTENANCE INSTRUCTIONS 1202...
-
Page 3: Spare Parts
By doing so, You will ensure safe operation 4 Right Leg 1 SN10004 Sealing Gasket 1 SN10040 of the unit, and enjoy trouble free service from your Clarke hydraulic crane. 5 Jib 1 SN10005 Reservoir 1 SN10041... -
Page 4: Safety Precautions
• When replacing parts, use only parts supplied by Clarke International as per the parts list on page 10. High tensile bolts are used in the construction of this crane. NEVER replace them with standard bolts. -
Page 5: Parts Diagram
PARTS DIAGRAM ASSEMBLY NOTE: During assembly, unless otherwise stated, nuts and bolts should be finger tight only. They should be fully tightened, once assembly is completed, in the manner described below. All figures in brackets, refer to the parts list item numbers. Attach the two castors to the Base using the bolts supplied, tighten the bolts securely. -
Page 6: Maintenance
(it may be necessary to disconnect ram from jib to access plug. cure. All ancillary parts must be disconnected, i.e. exhaust system, speedo Top up to level of hole with Clarke hydraulic oil (pt. no. 3050830). Replace the cable, electrics etc., and only lifting points recommended by the vehicle plug and refit jib as described in the assembly instructions.
Need help?
Do you have a question about the CFC100 and is the answer not in the manual?
Questions and answers