Defining The Device Role - Gigaset N670 IP PRO Installation, Configuration And Operation

Connecting the power supply
Your N670 IP PRO is supplied with sufficient power via PoE (Power over Ethernet) if
the device is connected to an Ethernet switch with PoE functionality (PoE IEEE802.3af
class 1). In this case, you do not need to connect the device to the mains power
supply.

Defining the device role

On delivery a N670 IP PRO device is configured as All in one device. It is able to upgrade the
device to a N870 IP PRO Multicell System component via license key. In this case the device role
can be changed.
You can use the device button on the front side to change the role of the device. The following
settings are possible:
•
Base station
•
All in one (integrator/DECT manager/base station) with dynamic IP settings
•
All in one (integrator/DECT manager/base station) with fixed IP settings
•
DECT manager and base station
All other roles must be set via the web configurator.
Selecting the role
Press the device button for at least 10 seconds until all LED switch off
. . . the device is now in programming mode.
Base station:
Release the button . . . the right LED lights green.
This role is only to be used for a slave base station in a mini multicell system (
Licenses are required for integration into a large multicell system (
All in one with dynamic IP settings:
Short press the device button until both LED light blue. . . . The IP
address will be assigned by a DHCP server in your network.
All in one with fixed IP settings:
Short press the device button until the right LED lights blue. . . . The
following IP settings are set:
IP address:
Subnet mask:
DECT manager and base station:
Short press the device button until the left LED lights blue and the
right LED lights green.
This role is only needed in combination with a virtual/embedded Integrator.
192.168.143.1
255.255.0.0
First steps
p. 8).
p. 73).
13