Wall Mounting; Setting Up A Mini Multicell System - Gigaset N670 IP PRO Installation, Configuration And Operation

First steps
Saving the selected role
The selected role is automatically assigned to the device, when the
button is pressed for four seconds . . . both LED light red. The device
is reset and rebooted (this can take up to 5 minutes).
When changing the device role the system is reset to factory setting. This means,
that existing configuration and user data will be lost.
If you change the role of a device that has been acting as Integrator, you should save
the configuration previously (

Wall mounting

N670 IP PRO is intended for wall mounting. After connecting the LAN cable you can place it to
the destined location.
Fix the device to the wall with two screws:
Drill holes with the vertical spacing of 110 mm.
Affix wall plugs and secure the screws. Let the screws
protrude by approx. four mm.
Hang the device on the screws.

Setting up a mini multicell system

You have installed a N670 IP PRO and want to expand the range of your DECT network (
Install one or two additional N670 IP PRO as slave base stations.
Change the role of the slave base stations to Base.
Via device button:
Via the web configurator:
On the master device add the slave base stations to the DECT network (
14
p. 80).
max. ø 8 mm
max. 3 mm
max. ø 4 mm
p. 13
p. 82
p. 8).
p. 26).