Setting Boost Mode Manually - Elko Smart ZB Thermostat 16 A User Manual

Setting boost mode manually

12
You can enable and disable boost mode manually.
When enabled the temperature increases by 2° C for temperature control modes
(P1 to P8) and by +2 for regulator mode (P9) over the setpoint.
To enable boost mode:
1. Press O button once to enter boost menu.
+1 flashes on thermostat matrix.
NOTE: The thermostat will exit boost mode if there is no interaction within
5 seconds after pressing O button.
2. Use +/- button to navigate between the boost hours from +1 to +3
3. Select boost hour and press O button to confirm selection.
For example:
If current setpoint is 12° C and you enable boost mode by selecting +3.
The boost mode will set the setpoint temperature to 14° C for next 3 hour. After 3
hour setpoint will return to 12° C.
Smart ZB Thermostat 16 A
DUG_ZB Thermostat 16 A_ELKO-00