Smart ZB Thermostat 16 A
DUG_ZB Thermostat 16 A_ELKO-00
6. Long press the O button until Jn is displayed and then release the button to
initiate joining.
NOTE: If you have already paired your thermostat, and want to change
the preset mode during the current pairing process, you will need to
perform a factory reset. Otherwise, the thermostat will be paired with the
previous preset mode. Refer
"Jn" will flash on the matrix.
7. In the app, tap Confirm device display Jn and than tap Start Configuration
(C).
Cancel
How to pair device
For commissioning, long press the O button
> 3s until "Jn" is displayed on the matrix.
Note: To change the preset mode, user need
to do factory reset on device.
8. Wait for a few seconds until the wireless
green.
9. After the device is added in the app, assign a room to enable settings and
than tap Done.
NOTE:
•
Assigning a room, creates a group to control the thermostats, refer
using the device, page
•
Refer
changing the device location, page 18
thermostat, if you did not assign the room at Step 9.
resetting the device, page
C
LED on the thermostat turns
25.
39.
to assign a room to the
15