Elko Smart ZB Thermostat 16 A User Manual page 24

Screen brightness settings
Active brightness level
Idle brightness level
Screen active duration
24
You can increase/decrease the LED brightness on the thermostat using the app.
Settings
Sensors Settings
Temperature Detection
Air Temperature
Temperature Calibration ? -9.0 C
Rated Power Settings
Rated Power Value ? 0 W
Child Protection Settings
Child Lock
Screen Brightness Settings
A
Active Brightness Level
100%
B
Idle Brightness Level
100%
C
Screen Active Duration 1 Min(s) 0 Sec(s)
You can configure the brightness of the LEDs when the thermostat is active
(during interaction):
1. Tap Active Brightness Level (A).
2. On the slide up menu, adjust the desired brightness level then tap Save.
NOTE:
• Default active screen brightness is 100%
• The screen brightness range is 1%~100%, and the setting accuracy is
1%.
You can configure the brightness of the LEDs when thermostat is inactive (after
time-out of screen active brightness).
1. Tap Idle Brightness Level (B).
2. On the slide up menu, adjust the desired brightness level then tap Save.
NOTE:
• Default idle screen brightness is 0%
• The screen brightness range is 0%~100% and it should not be more than
active brightness level.
The thermostat can be configured to set a timeout for the LED when it is active.
1. Tap Screen Active Duration (C).
2. On the slide up menu, select required active duration:
• 5 Secs
• 10 Secs
• 30 Secs
• 45 Secs
• Customized Duration: use +/- or drag the sliding bar to change the
Active Duration, which ranges from 1 minute to 60 minutes.
NOTE: Default screen active duration is 60 s.
NOTE: In the event that the thermostat is removed from the ELKO system, the
brightness setting will be retain.
Smart ZB Thermostat 16 A
DUG_ZB Thermostat 16 A_ELKO-00