Elko Smart ZB Thermostat 16 A User Manual page 22

Guard temperature
Valve protection settings
Valve protection
22
To set the maximum and minimum guard temperature:
• On setting page, tap Max Guard Temperature (D) to set upper temperature
limit of the floor sensor and then tap Save.
NOTE: The temperature ranges form 5°C to 19°C and maximum guard
temperature should be higher than minimum guard temperature
• Tap Min Guard Temperature (E) to set lower temperature limit of the floor
sensor and then tap Save.
NOTE: The temperature ranges form 21°C to 40°C and minimum guard
temperature should be lower than maximum guard temperature
Hydronic underfloor heating and boiler connections require valves and protection,
while electric underfloor heating does not use valves. This feature can only be
used in hydronic applications.
The valve protection can be enabled or disabled by tapping the toggle switch (A)
on the valve protection setting.
NOTE: Activate output every two weeks to prevent valve calcification. It only
supports Enable/Disable feature.
Settings
Sensors Settings
Temperature Detection Air Temperature
Temperature Calibration ? +0.1 C
Valve Protection Settings
A
Valve Protection
Child Protection Settings
Child Lock
Screen Brightness Settings
Active Brightness Level
100%
Idle Brightness Level 100%
Screen Active Duration 1 Min(s) 0 Sec(s)
Smart ZB Thermostat 16 A
DUG_ZB Thermostat 16 A_ELKO-00