Smart ZB Thermostat 16 A
surfaces, such as a concrete floor. A short cycle time is more appropriate for faster
heating surfaces, such as an electric panel heater.
Initial preset configuration (by default)
When the thermostat is first powered on or immediately after a factory reset, by
default "P5" flashes on the matrix LED's if there is no external sensor connected,
or "P8" if there is any external sensor connected.
Modifying the preset value
To modify the preset from default value, simultaneously press "O" and "+" for 10 s
to enter advanced settings menu. Then press + button on the thermostat, it
increases the preset value by 1 and when – button is pressed, it decreases the
preset value by 1.
For example, when + button is pressed, preset P1 becomes P2, continue to press
the + button, and the preset changes to P3, P4...P9.
Similarly, when – button is pressed, preset P9 changes to P8, continue to press
the – button, preset changes to P7, P6...P1.
8
DUG_ZB Thermostat 16 A_ELKO-00