Elko Smart ZB Thermostat 16 A User Manual page 21

Smart ZB Thermostat 16 A
Sensors settings
Temperature detection
Temperature calibration
Floor sensor type
DUG_ZB Thermostat 16 A_ELKO-00
Settings
Sensors Settings
Temperature Detection
Air Temperature
A
Temperature Calibration ? -9.0 C
B
Temperature Detection Floor Temperature
C
Floor Sensor Type ? -- K
Temperature Calibration
? 0.0 C
D
Max Guard Temperature
30 C
E
Min Guard Temperature 10 C
Valve Protection Settings
Valve Protection
Child Protection Settings
Child Lock
Screen Brightness Settings
Active Brightness Level 100%
Idle Brightness Level
100%
Screen Active Duration 1 Min(s) 0 Sec(s)
You can check the sensor type (A) under temperature detection, based on your
preset.
Air Temperature: for preset P1 to P6.
Floor Temperature: for preset P7 to P8.
NOTE: Sensor settings are not available for regulator mode (P9).
To set the temperature calibration:
1. Tap Temperature Calibration (B) for a slide-up menu.
2. Drag the sliding bar or use –/+ button to set the temperature calibration.
NOTE: The temperature calibration ranges from -9°C to +9°C and can be
adjusted in 0.1°C increments.
3. Tap Save.
To select the floor sensor type:
1. Tap Floor Sensor Type (C) for slide up menu.
2. Select the sensor type (kOhm) form the following list.
• 10K
• 12K
• 15K
• 33K
• 47K
NOTE: Select correct floor sensor type which is installed and then you
can set calibration and guard temperature.
21