Important Safety Instructions - Epson Stylus Photo RX500 User Manual

Important Safety Instructions

Before using your RX500, read and follow these safety instructions:
Be sure to follow all warnings and instructions marked on the RX500.
Use only the type of power source indicated on the RX500 label.
Connect all equipment to properly grounded power outlets. Avoid using outlets on
the same circuit as air control systems or other high-load devices that regularly switch
on and off.
Place the RX500 near a wall outlet where the plug can be easily unplugged.
Don't let the power cord become damaged or frayed.
If you use an extension cord with the RX500, make sure the total ampere rating of the
devices plugged into the extension cord does not exceed the cord's ampere rating.
Also, make sure the total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet's ampere rating.
Avoid electrical outlets controlled by wall switches or automatic timers.
Keep your RX500 and computer away from potential sources of electromagnetic
interference, such as loudspeakers or cordless telephone base units.
Avoid locations that are subject to rapid changes in heat or humidity, shocks or
vibrations, or dust.
Leave enough room around the RX500 for sufficient ventilation.
Don't place the RX500 near a radiator or heating vent or in direct sunlight.
Place the RX500 on a flat, stable surface that extends beyond its base in all directions.
It will not operate properly if it is tilted or at an angle. Leave enough space in front of
the RX500 (at least 9 inches) so it doesn't tip forward and fall off of the work surface.
Turn off and unplug the RX500 before cleaning. Clean with a damp cloth only.
Don't spill liquid on it.
Always turn the RX500 off using the
switch on a power strip or unplug the RX500 until the
Turning off
Don't block or cover openings in the RX500 case or insert objects through the slots.
Except as specifically explained in your documentation, do not attempt to service the
RX500 yourself.
Unplug the RX500 and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the
product; if the product has been dropped or the case damaged; if the product does not
operate normally or exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
126
Requirements and Notices
disappears from the LCD panel.
button. Don't turn off the power using a
P On
P On
light is off and