Scanning to a File
Follow these steps to scan directly to a file on your computer:
1. Open the scanner lid.
2. Place your photo or document face down on the glass in the upper left corner.
Move your document about 0.1 inch from the top and side edge so your
entire document is scanned.
Note:
If you place your photo or document too close to the edges of the scanner glass,
the edges of the photo or document may not be scanned.
To scan a thick document, you can remove the scanner lid. Turn off the RX500 and
open the scanner lid completely. Then disconnect the cord from the TPU
connector and pull the lid straight up. Turn on the RX500 and gently press down the
original to keep it flat on the scanner glass as you scan. When you're finished, be
sure to turn off the RX500 before you replace the scanner lid and plug in the
connector.
60
Scanning to a Computer
Move the
photo in about
0.1 inch from
the edges
Orient the
photo as
shown