Epson AcuLaser M7000N series User Manual page 90

Epson AcuLaser M7000 Series User's Guide
The required time to process the print data exceeded the print engine speed because the current page is
too complex. Press the Start/Stop button to resume printing, or cancel the print job. To cancel the
print job see "Canceling Printing" on page 96. If this message appears again, select On as the
Page Protect setting in the control panel's Setup Menu or select Avoid Page Error on the printer
driver.
If you continue to receive this message when printing a particular page, try simplifying the page by
limiting the number of graphics or reducing the number and size of fonts.
To avoid this error, it is recommended that you set the Page Protect setting to On and add more
memory to the printer. See "Setup Menu" on page 64 and "Memory Module" on page 110 for details.
RAM CHECK
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Feed Roller MP, Replace Feed Roller C1, Replace Feed Roller C2, Replace Feed Roller
C3
The feed roller MP, C1, C2, or C3 has reached the end of its service life and needs to be replaced. If this
error occurs, consult your dealer.
Replace Fuser
The fuser has reached the end of its service life and needs to be replaced. If this error occurs, consult
your dealer.
Replace Toner Cartridge
Printing is possible until the printout fades. To stop the printout from fading, remove the imaging
cartridge and gently rock it back and forth. Then, reinstall the imaging cartridge and try printing
again. If the fading is not resolved by this procedure, replace the imaging cartridge. See "Replacing
Consumable Products" on page 116 for instructions.
Replace Transfer Unit
The transfer unit has reached the end of its service life and needs to be replaced. If this error occurs,
consult your dealer.
Using the Control Panel 90