Table of Contents
Advertisement
5.6
Wall mounting
Preparation
Note the position of the securing bar, see also section "Dimension drawings (Page 89)".
When supplied, the securing bar is in the wall mounting position. You do not need to prepare the
device any further.
If the securing bar is in the rail mounting position, note the section "Changing the position of the
securing bar (Page 50)".
Tools
To mount the device on a wall, you require the following:
• 2 wall plugs with a diameter of 6 mm and a minimum length of 35 mm.
• 2 oval-head screws with a diameter of 3.5 mm to 4 mm and a minimum length of 50 mm.
Note
Use suitable fitting material depending on the mounting surface.
Mounting on a concrete wall
The following table shows the size of the drill hole and the required fastening material using a
concrete drill hole as an example:
Base
Drill hole
Fastening material
Assembly
Note
The wall mounting must be capable of supporting at least four times the weight of the device.
To mount the device on a wall, follow the steps below:
1. Prepare the wall mounting with drilled holes and plugs. For the precise dimensions, refer to
the section "Dimension drawings (Page 89)".
2. Turn the upper screw in to the wall so that 10 mm remains jutting out.
3. Hang the device with the keyhole hanging mechanism on the rear on the screw.
4. Fix the device to the wall with the lower screw.
5. Connect the electrical connecting cables, refer to the section "Connecting up (Page 53)".
SCALANCE XC-300
Operating Instructions, 10/2022, C79000-G8976-C584-01
Concrete
Depth
Min. 45 mm
Diameter
6 mm
Plugs
6 x 35
Oval-head screws
4 x 50
Installing and removing
5.6 Wall mounting
49
Advertisement
Table of Contents
