Table of Contents
Advertisement
Troubleshooting
8.3 Loading a firmware file via TFTP
6. Assign an IP address to the device using DHCP or SINEC PNI.
7. In a Windows command prompt, go to the directory where the file with the new firmware is
located and use the following command:
tftp -i <IP address> put <firmware file>.
Note
You can enable TFTP in Microsoft Windows as follows:
"Control Panel" > "Programs and Features" > "Turn Windows features on or off" > "TFTP Client".
Once the firmware has been transferred completely to the device and validated, the device
restarts. This may take a few minutes.
74
Operating Instructions, 10/2022, C79000-G8976-C584-01
SCALANCE XC-300
Advertisement
Table of Contents
