Unpacking And Installation; Shipping Carton; Unpacking; Location - Fisher Scientific Isotemp 05FFEEFSA Operation And Installation Manual

Unpacking and Installation

Shipping Carton

This should be inspected upon delivery. When received,
carefully examine for any shipping damage before unpacking.
If damage is discovered, the delivering carrier should both
specify and sign for the damage on your copy of the delivery
receipt.
Open the carton carefully making certain that all parts are
accounted for before packaging materials are discarded.
After unpacking, if damage is found, promptly report it to the
carrier and request a damage inspection promptly.
IMPORTANT: Failure to request an inspection of damage
within a few days after receipt of shipment absolves the car-
rier from any liability for damage. You must call for a damage
inspection promptly.

Unpacking

Use the list below when unpacking to verify that the complete
unit has been received. Do not discard packing materials until
all is accounted for.
The following items are included in the shipment:
• Freezer
• Operation Manual
• Inspection Tag

Location

Place the unit on a floor that is strong enough to support the
unit when it is fully loaded. To level the unit, adjust the leveling
legs at the bottom. To level the unit, the leveling legs can be
either turned clockwise to raise that side of the unit, or turn
counter-clock wise to lower that side. Locate the unit away
from direct sunlight and sources of heat (heater etc). Locate
the unit in most convenient place and near a grounded
electrical outlet.

Clearance

Allow 1" of space on the sides. Allow at least 4" above the top
of the unit and the same amount of space between the back
and the wall.
8 | Unpacking and Installation

Electrical

With the exception of Explosion-Proof models, all units must
be connected to a grounded outlet matching the nameplate
and/or the information furnished in this manual.
If you are not sure about the outlet, you should contact a
qualified electrician for assistance.
The unit should always be connected to its own individual
outlet.
Explosion-Proof models do not come supplied with a
cord and plug. Units must be hard-wired by a qualified
electrician.

Be Advised

Isotemp Freezer, Flammable Materials Storage & Explosion Proof Freezers
CAUTION: DO NOT REMOVE, under any
circumstances, the grounding prongs from the
3-prong power cord supplied with all units.No
cord/plug is supplied with Explosion-Proof
units.Contact a qualified electrician to hard-wire
unit.
CAUTION: DO NOT USE electrical extension
cords that may result in voltage loss and possible
hazardous operation.
DANGER: RISK OF CHILD ENTRAPMENT.
BEFORE YOU THROW AWAY YOUR OLD
FREEZER:
• TAKE OFF DOORS.
• LEAVE THE SHELVES IN PLACE SO
THAT CHILDREN MAY NOT EASILY
CLIMB INSIDE.
DANGER: UNLESS UNIT IS SPECIFICALLY
DESIGNED FOR COMBUSTIBLE OR
FLAMMABLE ATMOSPHERES DO NOT USE IN
THE PRESENCE OF FLAMMABLE OR
COMBUSTIBLE MATERIALS OR EXPLOSIVE
GASES. DO NOT USE IN PRESENCE OF
PRESSURIZED OR SEALED CONTAINERS—
FIRE OR EXPLOSION MAY RESULT CAUSING
DEATH.