ABB GLA451 User Manual page 99

USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Enable the EDDS
1. Click Setup on the
Figure 93: Setup button on the User Interface Control Bar
2. Click on the DCS tab at the top of the
3. Use the radio buttons to Enable or Disable the EDDS.
4. Use the drop down selection box to set the dilution factor.
5. Click Save.
6. Click Close to begin the dilution.
Figure 94 shows the DCS Screen for the EDDS enabled.
User Interface Control Bar
Setup
Figure 94: Enable EDDS
. (Figure 93)
menu selection bar. (Figure 94)
99