ABB GLA451 User Manual page 107

USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Software Setup
1. If applicable, in the parameter window of the
the optional MIU and WVISS accessories are not enabled. (Figure 103)
a. Disable the
optional accessory. To disable the MIU:
i.
Figure 103: Setup Button on the User Interface Control Bar
ii.
iii.
iv.
v.
Figure 104: Control Menu for the (Optional) Multi-Port Inlet Unit (MIU)
Multi-Port Inlet Unit (MIU)
User Interface Control Bar
Click Setup on the
Click on the MIU tab at the top of the
Uncheck the checkbox at the bottom of the screen to disable the
MIU. (Figure 104)
Click Save Changes. (Figure 104)
Setup
Click Close to exit the
User Interface Control Bar
if your analyzer is configured with this
. (Figure 103)
Setup
screen. (Figure 104)
menu. (Figure 104)
, verify that
107