Table of Contents
Advertisement
USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
b. Disable the
Water Vapor Isotope Standard Source (WVISS)
if your analyzer is
configured with this optional accessory. To disable the WVISS:
User Interface Control Bar
i.
Click Setup on the
. (Figure 105)
Figure 105: Setup button on the User Interface Control Bar
ii.
Click on the WVISS tab at the top of the
Setup
screen. (Figure 106)
iii.
Select Single Stage WVISS Disabled in the drop down menu in the
WVISS mode section. (Figure 106)
iv.
Click Save Changes. (Figure 106)
v.
Click Close to exit the
Setup
menu. (Figure 106)
Figure 106: Control Menu for the (Optional) WVISS
108
Advertisement
Table of Contents
