Table of Contents
Advertisement
6.3 Common
The displayed device name and the "Host Individual Address" (individual address of the device)
can be changed via the database entry within your ETS project.
In the "Individual address" input field, the individual KNX address of the currently used KNXnet/IP
tunneling connection can be changed. To check if the desired individual address is not already
available in your KNX installation, the button "Address free?" can be pressed.
The KNX IP LineMaster 762.1 secure supports up to 8 connections simultaneously. A separate
individual address is used for each connection.
The ETS can access configured IP interfaces even without a database entry. If the configuration
does not correspond to the conditions of the installation, it must be adapted via the database entry
in the ETS project.
The individual KNX device address as well as the individual KNX addresses for the additional
tunneling connections can be changed via the database entry within the ETS project after the
device has been added to the project. See section "ETS database - Additional individual
addresses".
The KNX IP LineMaster 762.1 secure has, like all programmable KNX devices, an individual
address with which the device can be addressed. This is used, for example, by the ETS when
downloading the interface via the KNX bus.
For the interface function, the device uses additional individual addresses that can be set in the
ETS (for ETS 5.7 or newer). If a client (e.g. ETS) sends secure telegrams to the KNX bus via the
KNX IP LineMaster 762.1 secure, these contain one of the additional addresses as the sender
address. Each address is assigned to a connection. Thus, response telegrams can be forwarded
definitely to the respective client.
The additional individual addresses must be from the address range of the bus line in which the
interface is located and must not be used by another device.
Example:
Individual address:
KNXnet/IP tunneling connection 1:
KNXnet/IP tunneling connection 2:
KNXnet/IP tunneling connection 3:
KNXnet/IP tunneling connection 4:
KNXnet/IP tunneling connection 5:
KNXnet/IP tunneling connection 6:
KNXnet/IP tunneling connection 7:
KNXnet/IP tunneling connection 8:
© 2022 WEINZIERL ENGINEERING GmbH
1.1.0 (device address in the topology)
1.1.240 (1. additional individual address)
1.1.241 (2. additional individual address)
1.1.242 (3. additional individual address)
1.1.243 (4. additional individual address)
1.1.244 (5. additional individual address)
1.1.245 (6. additional individual address)
1.1.246 (7. additional individual address)
1.1.247 (8. additional individual address)
Seite 19/38
Advertisement
Table of Contents
