Konica Minolta SRX-101A Service Manual page 91

SRX-101A CUSTOMER PRESENTATION GUIDE
e
Point out each component as you explain it.
r
Study the Operation Manual thoroughly so that you can answer any questions correctly
and informatively.
If by chance there is a question that you cannot answer immediately, make sure to
£
inform the customer when you will have an answer ready.
15-4. How to Mix the Processing Chemicals
q
Explain how to mix the developer and fixer replenisher solutions using the replenish tanks.
Go through the directions printed on the chemical packages.
£
Explain clearly the differences between the developer and fixer replenisher solutions, so
£
that the customer will not confuse them during operation.
Explain the mixing procedure along with the following precautions :
£
a) Do not reverse the steps in the developer replenisher (Chemical A, Chemical B
Chemical C) mixing procedure.
b) Do not reverse the steps in the fixer replenisher (Chemical A, Chemical B) mixing
procedure.
c) Mix the chemicals thoroughly.
d) Use only the amount of water specified on the package.
e) Explain what measures to take if processing solution comes into contact with the skin
or eyes.
w
If the customer will use a chemical mixer, explain its features and operating procedures.
More and more customers are using chemical mixers these days. So it is a good idea to
£
become familiar with their features and operation.
15-5. Operational Procedures
q
Explain how to operate the SRX-101A.
Be sure to explain these points using the Operation Manual.
£
Demonstrate how to switch both the building's power breaker and the main unit power
£
switch ON and OFF. Have the customer actually perform this procedure until he/she
remembers all the steps involved.
Make certain that the processor's initial settings are correct.
£
Explain the operational procedures in the following order, emphasizing how to use the
£
control panel on the main unit.
a) Take this opportunity to recheck the cycle time and processing conditions you set
during installation.
b) How to select the standby modes.
c) How to supply replenisher and processing solution.
d) Other procedures.
Explain what film sizes and types are compatible with the SRX-101A.
£
After the processing solution temperatures have reached their operational levels, run a
£
few sheets of already developed 24x30cm(10x12inch) film through the processor and
explain how the film is transported.
Explain how to insert single-face emulsion film.
£
SERVICE MANUAL
86