Konica Minolta SRX-101A Service Manual page 43

5-3. Trouble Caused by the Film Processor
No. TROUBLE
1 The processed film
surface is coming out
grimy.
2 The film is coming out
damaged.
3 Uneven developer
(1)Poor solution
circulation
CAUSE
• The processing tank rollers • Clean the rollers.
are dirty.
• The processing solutions
are dirty.
• The wash water is dirty.
• The cleaning film mainte-
nance procedure is not
being properly carried out.
• The film holder in the feed • Clean the feed tray film
tray is dirty.
• Improperly set or damaged • Set the racks properly in place.
processing racks.
• Improperly set or damaged • Set the rack properly.
drying racks.
• There are pointed or edges • Repair the damaged area.
damaged areas in the feed • Replace the tray.
tray film holder.
• Damaged guides in the
processing tanks.
• Rollers have not been set
properly in their racks.
• Improper roller rotation.
• Improperly set drive shaft.
• Loose or damaged roller
pressure springs
• Damaged gears.
• Damaged or worn
developer circulation pump
(P1).
• Damaged circulation pipe
lines.
• Blocked circulation pipe
lines.
TROUBLE SHOOTING
RESPONSE
• Replace the processing solutions.
• Clean the processing tanks.
• Check the wash water level.
• Replace the electromagnetic
wash water supply valve if dam-
aged.
holder.
• Repair the damaged or replaced
the racks.
• Repair the damage or replace
the rack.
• Clean the film holder.
• Repair the damaged guide.
• Set the rollers properly.
• Replace any damaged drive shaft
supports.
• Check if the drive shaft supports
are set properly.
• Set the springs properly in place.
• Replace damaged springs.
• Replace damaged gears.
• Replace the pump.
• Repair the pipe line.
• Clean the pipe line.
ADVICE To CUSTOMER
• Remind about checking
and maintenance tasks.
• Remind about the cleaning
film procedures.
• Show the proper method
for setting the racks using
the guide arrows.
• Show the proper method
for setting the rollers.
SERVICE MANUAL
40