Operation; Parameter For The Basic Configuration; Field Device Tool / Device Type Manager (Fdt / Dtm); Installation - KROHNE OPTIWAVE 3500 C Handbook

DESCRIPTION OF HART INTERFACE
9

9.6.2 Operation

INFORMATION!
For more data, refer to HART® menu tree for AMS on page 145 .

9.6.3 Parameter for the basic configuration

Due to AMS requirements and conventions, there are differences when operating the signal
converter with AMS and operating using the local keyboard. The service menu parameters are
not supported and simulation is only possible for current outputs. The online help for each
parameter contains its function number as a reference to the local device display.

9.7 Field Device Tool / Device Type Manager (FDT / DTM)

A Field Device Tool Container (FDT Container) is a PC program used to configure HART®,
PROFIBUS and FOUNDATION™ fieldbus devices. To configure a device, an FDT container uses
the applicable Device Type Manager (DTM).

9.7.1 Installation

Before you operate the device, the Device Type Manager (Device DTM) must be installed in the
Field Device Tool Container. You can download this .msi file from our website. For installation
and configuration data, refer to the documentation that is supplied with the Device DTM in the
"Downloads" section of the website.
9.7.2 Operation
The DTM and the device's local display use almost the same procedures to operate the signal
converter. For more data, refer to Operation on page 54.

9.8 Process Device Manager (PDM)

The Process Device Manager (PDM) is a Siemens PC program designed to configure HART
PROFIBUS devices. Device Descriptions (DDs) are used to integrate different devices into the
PDM.
9.8.1 Installation
Install Device Description files supplied in the Device Install HART® PDM folder. This is
necessary for each type of field device that is used with SIMATIC PDM. This folder is available for
download from the website.
If you use PDM version 5.2, refer to PDM manual, section 11.1 - Install device / Integrate device
into SIMATIC PDM with Device Install.
If you use PDM version 6.0, refer to PDM manual, section 13 - Integrating devices.
For more data, refer to "readme.txt". You can find this file in the Installation Kit.
144
www.krohne.com
OPTIWAVE 3500 C
02/2023 - 4005813604 - MA OPTIWAVE 3500 R04 en
®
and