Deployment Notes; Configuring A Call Server Or Csv Connection - Nortel 1000 Configuration Manual

Deployment Notes

Configuring a Call Server or CSV Connection

1
2
To support the creation of an IP/DN map, the Application Gateway
•
must be on the same LAN segment as the call server. The Application
Gateway must communicate with the call server via its Embedded
LAN (ELAN) to retrieve information for the IP/DN map.
If you want a separate administrator account on the PBX for log ins
•
from the Application Gateway, the administrator account requires
overlay 81 and 117 access only. You must also enable multi-user login
on the call server and signaling server. This ensures a speedy and
complete synchronization. Port speed can also impact the integrity of
the data received during synchronization.
When user traffic reaches the concurrent session capacity, you can
•
increase capacity by installing additional Application Gateways, all
pointing to the same Nortel Messaging server. Because a load balancer
can handle only HTTP signaling, you will need to configure groups of
phones to use a particular Application Gateway by pointing their
application server setting to the IP address of the Application
Gateway.
Refer to the Application Gateway Release Notes for additional
•
information about capacity, deployment, and operation.
The following one-time setup applies to all Voice Office applications.
To configure a call server or CSV connection:
Open the Administration Tool: From a web browser, enter the URL
https://AG_ipAddress:AG_adminPort.
Go to the Operation > Voice Office > IP Phone page.
Chapter 1 Voice Office Configuration Requirements
Specifying a Source for Phone IP-to-DN Mappings
Voice Office Application Suite Configuration Guide
11