Table of Contents
Advertisement
July 1999
LOGIN (L)
Introduction
The LOGIN (L) command enables you to access an HLC or the switch to
perform maintenance functions.
Command prompts
When you are not logged in, the MMI prompt is HLC>.
When you are logged in to a one-card system, the MMI prompt is HLC::>.
When you are logged in to a multi-card daisy-chained system, the MMI
prompt is HLC<XX>, where <XX> is the address of the card into which
you are logged.
To log in to an HLC
1
For one-card installations, log in by typing LOGIN or L and pressing Enter.
For daisy-chained installations, log in by typing LOGIN <XX> or L <XX>,
where <XX> is the one- or two-digit HLC address, and pressing Enter. See
"Installing multiple-HLCs" on page 28.
The LOGIN command and the address must be separated by a space. For
example, to log in to an HLC with an address of 03, type the command
LOGIN 03, L 03, LOGIN 3, or L 3 and press Enter.
Result: The MMI prompts you for the system password.
2
Type the password and press Enter. The default password is HLCLINK.
a. You can change the password later through the SET CONFIG
command. See "SET CONFIG (S C)" on page 114.
b. The password is case-sensitive.
Line Card Configuration Guide
Maintenance
91
Advertisement
Table of Contents
