Set Time (S T) - Nortel HomeOffice II User Manual

Maintenance

SET TIME (S T)

Introduction
Use the SET TIME or S T command to set the HLC's clock to a time other than
that kept at the switch's clock. This is helpful if, for instance, the company's
switch and a user's home office are in different time zones.
Note: The SET TIME command is only effective if autoclock is disabled
through the SET CONFIG (S C) command. See "SET CONFIG (S C)" on page
114.
To change the time kept by the HLC
1 If you are not already logged in, log in to the MMI.
See "LOGIN (L)" on page 91.
2 At the command prompt, type SET TIME or S T and press Enter.
Result: The MMI's display of its current time and prompt for a new time is
similar to the following figure:
Wed, 05-26-1999
HLC::>s t
Current Time 17:30:19
Enter <hh:mm:ss>
3 Type the time in 24-hour HH:MM:SS format and press Enter.
Result: The HLC displays the information that it receives.
134
17:40:28
or <Return>
Standard 01.02
Meridian HomeOffice II