Table of Contents
Advertisement
IP NETWORK
CONFIGURATION
This page allows basic
If your network has a
list controllers along with their IP addresses, and can use the hostname to identify the IP address of a
specific controller. By default, all
hostname set to "
CBXi
If your network does not have a
is made up as follows:
The first byte of the
•
•
The 6 digits of the numerical part of the serial number grouped into 3 sets of 2 digits to form the last
3 bytes of the IP address.
For example,
CBXi
Configuring the IP connection
also
mask
in CIDR format. See
Recovery IP Address
If the primary IP cannot be reached – for example if the primary is set to automatic and there is no DHCP
server available, then the user must use the Recovery IP Address to access the Web UI and properly
configure the primary. The recovery is only designed for access to the web UI.
The factory default value is based on the serial number in the same way as the primary, but the Recovery
IP Address should not be changed or disabled unless it interferes with other network operations.
Note:
A button-press reset (see
©ABB 2022 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
IP
configuration, identifying the current device on the
DHCP
server, click the
Automatic (DHCP)
CBXi
devices leaving the factory are configured to use DHCP, and have a
" followed by the controller's serial number – e.g.
DHCP
server, then the
IP address
is set to
10
with serial number
901001A
on page 31. The
Subnetwork (Subnet)
CBXi IP Controller |
box. You can then use
CBXi901004A
CBXi
controller will use a default
will be allocated the default IP address of
input is also used to specify the
IP Address
on page 7 for a full explanation.
CBXi Web UI
IP
network.
BACnet
discovery to
IP
address, which
. See
10.90.10.01
subnet
21
Advertisement
Table of Contents
