Ip Network Menu; Configuration - ABB Cylon FBXi Series User Manual

IP NETWORK MENU

CONFIGURATION

This page allows basic
If your network has a
controllers along with their IP addresses, and can use the hostname to identify the IP address of a specific
controller. By default, all
set to " " followed by the controller's serial number – e.g.
FBXi
If your network does not have a
made up as follows:
•
The first byte of the IP address is set to 10
•
The 6 digits of the numerical part of the serial number grouped into 3 sets of 2 digits to form the last 3
bytes of the IP address.
For example, FBXi
Configuring the IP connection
Subnetwork (Subnet)
format. See
Recovery IP Address
If the primary IP cannot be reached – for example if the primary is set to automatic and there is no DHCP
server available, then the user must use the Recovery IP Address to access the Web UI and properly configure
the primary. The recovery is only designed for access to the web UI.
The factory default value is based on the serial number in the same way as the primary, but the Recovery IP
Address should not be changed or disabled unless it interferes with other network operations.
Note: A button-press reset (see
configuration to factory defaults.
©ABB 2023 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
IP configuration, identifying the current device on the
DHCP server, click the
Automatic (DHCP)
FBXi devices leaving the factory are configured to use DHCP, and have a hostname
DHCP server, then the
with serial number
901001A
on page 39. The
on page 8 for a full explanation.
Restarting, Resetting and upgrading the FBXi
FBXi Series |
box. You can then use
FBXi901004A
FBXi controller will use a default
will be allocated the default IP address of
input is also used to specify the
IP Address
FBXi Web UI
IP network.
BACnet discovery to list
IP address, which is
10.90.10.01
subnet mask
on page 80 will revert all IP
. See also
in CIDR
25