Table of Contents
Advertisement
Configuring the IP connection without CXproᴴᴰ
If there is no instance of
configure an individual
To access the Web UI, you must know the controller's IP address.
How to determine the IP address of a specific CBXi controller without CXproᴴᴰ
By default, all
CBXi
"
" followed by the controller's serial number – e.g.
CBXi
If your network has a
and use the hostname to identify the IP address of a specific controller.
For example, In the screenshot above, the
CBXi
with hostname
If your network does not have a
is made up as follows:
•
The first byte of the IP address is set to 10
•
The 6 digits of the numerical part of the serial number grouped into 3 sets of 2 digits to form the last
3 bytes of the IP address.
For example, a
10.93.91.21
default, as shown below, but the recovery IP address should be left at the default value so that it is
known in case of emergency.
Note:
For a laptop (or PC) to communicate with a
laptop's Ethernet port must be set to a subnet that is compatible with the CBXi's IP address.
For example, if the
something like
10.90.10.nn
©ABB 2022 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
CXproᴴᴰ
available with the appropriate
CBXi
controller using its built-in Web UI.
devices leaving the factory are configured to use DHCP, and have a hostname set to
DHCP
server, you can use IP scanning software such as
.
CBXi321043
DHCP
server, then the
CBXi
with serial number
, which is also used as the Recovery IP. The IP address can be changed from the
CBXi
CBXi
has an IP address of
with a subnet mask of
CBXi IP Controller |
Site
configuration, it is possible to
CBXi901004A
DHCP
server has allocated
CBXi
controller will use a default
will be allocated the Default IP address of
939121D
configured in this way, the IP address of the
, the laptop could have an address
10.90.10.01
.
255.255.255.0
Installation
AngryIP
to locate controllers
IP address
to
192.168.1.121
IP
address, which
34
Advertisement
Table of Contents
